Shown here is an array of devices that use superconductivity to gather, filter, detect, and amplify polarized light from the cosmic microwave background (relic radiation left over from the Big Bang) for NASA's BICEP2 telescope at the South Pole. The microscope shows a close-up view of one of the 512 pixels on the focal plane, displayed on the screen in the background. Each pixel is made from a printed antenna that collects polarized millimeter-wavelength radiation, with a filter that selects the wavelengths to be detected. A sensitive detector is fabricated on a thin membrane created through a process called micro-machining. The antennas and filters on the focal plane are made from superconducting materials. An antenna is seen on the close-up shot in the background with the green meandering lines. The detector uses a superconducting film as a sensitive thermometer to detect the heat from millimeter-wave radiation that was collected by the antenna and dissipated at the detector. A detector is seen on the close-up shot in the background to the right of the pink square. Finally, a tiny electrical current from the sensor is measured with amplifiers on the focal plane.